Bug #6390
Size of bar
| Status: | New | Start Date: | 09/21/2012 | |
|---|---|---|---|---|
| Priority: | Low | Due date: | ||
| Assigned to: | - | % Done: | 0% |
|
| Category: | GUI | |||
| Target version: | - | |||
| Platform: | Patch supplied: | No | ||
| Platform version: | Affected version: | master | ||
| Status info: | Causes crash or corruption: | No | ||
| Resolution: |
Description
The View>Decorations>Scale bar>Size of bar has a strange behaviour. It allows you to change the length of the scale bar, but it is strangely limited to two digits and will get reset if the value is not judged in the good range.
Try to input a value like 40 and zoom until 40m would be considered an acceptable value. There will be a few level of zoom where the bar is set to 40m. Once you zoom in or zoom out too far, it will get calculated as usual.
History
Updated by Magnus Homann 9 months ago
Yes, I also noticed it doesn't work. But I'm unsure how it should work, so I haven't fixed it. :-) Ideas?
Updated by Paolo Cavallini 9 months ago
I'm also unsure about the intended behaviour of the option. Perhaps if specified the bar should always be of the selected length (in map units or in mm)?